« previous next »
Pages: [1]

Author Topic: Electric Locked Switches (Also known as user protect switches in CTC)  (Read 2251 times)

westdetroit

  • Jr. Member
  • **
  • Posts: 79
Electric Locked Switches (Also known as user protect switches in CTC)
« on: July 21, 2021, 10:00:54 AM »
Hi. Would it be possible to make it so we can set user locked switches to "locked" in the editor on switches that are electric locked so that they will already be "locked" when you start a new sim?
Logged

DPump

  • Administrator
  • Full Member
  • *****
  • Posts: 215
Re: Electric Locked Switches (Also known as user protect switches in CTC)
« Reply #1 on: July 21, 2021, 10:13:48 AM »
It would be possible, probably similar to setting default state introduced a little while ago
Logged

westdetroit

  • Jr. Member
  • **
  • Posts: 79
Re: Electric Locked Switches (Also known as user protect switches in CTC)
« Reply #2 on: July 21, 2021, 11:17:24 AM »
You got it👍👍
Logged

DPump

  • Administrator
  • Full Member
  • *****
  • Posts: 215
Re: Electric Locked Switches (Also known as user protect switches in CTC)
« Reply #3 on: August 05, 2021, 05:30:53 AM »
This feature has now been implemented and will be available in 5.7. The similar feature "default state of switches", available since 5.1, has also been fine tuned, e.g. inclusion in undo/redo scheme and the interaction with route testing.
Logged

westdetroit

  • Jr. Member
  • **
  • Posts: 79
Re: Electric Locked Switches (Also known as user protect switches in CTC)
« Reply #4 on: August 05, 2021, 02:53:13 PM »
Sounds good. Not sure if you thought about this, and I actually thought about this for signals running time as well, but I was thinking that it should take 3 to 5 minutes to "unlock" them as the purpose of them is to allow time in case there is an approaching train. Just a thought.
Logged
Pages: [1]
« previous next »